恒壓閥 Constant pressure regulating valve

恒壓調節閥系列 Constant pressure regulating valve

應用氣動控制壓力及流量。

標準設計 恒壓閥閥體12個厚鋼板鍛壓設計工藝、閥芯及所有零部件采用AISI3016L或304制造，閥體內外噴砂拋光，膜片采用優質橡膠制成，溫可達到140℃

工作原理CPM-2恒壓調節閥由控制壓縮空氣的壓力大小來控制調節閥芯的位置，從而達到所需的壓力及流量

技術參數 生產壓力: 1000KPa(10bar)最小生產壓力: 0KPa(0bar)=大氣

溫度范圍:-10℃to至+95℃  溫度范圍(上隔膜PTFE/EPDM):-10℃to至+140℃(按要求更高)。

空氣壓力: 0 to 600kpa (0 to 6bar)  流量范圍Kv,全開(p=1bar): 大約23?/h.

流量范圍Kv,低能力(p=6bar): 大約2?/h.  可選擇的尺寸): 調節區域大約152?/h.(CIP區域)

Constant pressure regulating valve

Applications Pneumatic control pressure and flow.

Standard design Constantpressure valve body 12 of thick steel forgingdesignprocess, the spool and all parts manufactured by AlSl3016L or 304,sandblastingpolishing inside and outside the body, the diaphragm is made of high quality

rubber,the maximum temperature can reach 140℃

Working principlCPM-2constant pressure regulating valve controlled bythecompressed air pressure regulating valve to controlthe size ofthe position, so as to achieve the requiredpressure andflow

Technical parameters   Largestproducer of pressure: 1000KPa (10bar)

Minimumproduction pressure: 0KPa (0bar) =atmospheric

Temperaturerange:-10℃to +95℃ to

Temperaturerange (on the diaphragm PTFE /EPDM):-10℃toto + 140℃(higher on request).

Airpressure: 0 to 600kpa (0 to 6bar)

Flowrange Kv, fully open (p= 1bar): about 23?/h.

Flowrange Kv, low capacity (p= 6bar): about 2?/h.  

Optionalsizes): regulation of regional about 152?/h.(CIParea)